Cuckoo clock instructions manual

If a cuckoo clock is running slow, simply slide pendulum bob up the arm a bit. It's that hand carved oak leaf we wrote about earlier that gives weight to the pendulum. If the cuckoo clock is running fast, simply slide pendulum bob down a little. CUCKOO CLOCK SET UP: 1. Carefully remove the contents of box and place the clock face down on a padded surface (Be sure to save your box and 2. Open the back panel of the clock, remove the bellow clips and paper from the chime coil, then replace the back panel 3. Hang the clock level on the wall.  · Operating and setup instructions for mechanical cuckoo clocks. 1. Open the tatches on the back panel. 2. Remove the back panel of the cuckoo clock. 3. Now, pull out the wire clamps that are securing the two bellows. 4. Remove the cardboard under the strike gong of the cuckoo clock. 5. Check if the.

The other manufacturers have very similar instructions for setting up their quartz cuckoo clocks. 1. Turn the hands to the 12 o´clock position. 2. Set the switch on the left side of the cuckoo clock to the "Musik off" position, if your clock is a music cuckoo clock. 3. Anton Schneider Cuckoo Clock Assembly Instructions 1) Remove the clock from the carton by holding the frame, practicing caution to avoid pulling on the Turn the door latch so it is clear of the cuckoo door. 10) Unwrap the chain retaining wire at the bottom of the clock and let the chains fall toward the floor. For clocks with manual or. Replace the back panel. 4. Turn the clock onto its backside. Push aside the wire lever (4) to unlatch the cuckoo's door, allowing the door to swing freely. The wire latch should remain affixed to the clock body. 5. At the bottom of the case, you will see a paper packet which secures the clock's chains.

4. Carefully unwrap the chains underneath the clock and lower them to the floor so they are hanging free of one another. 5. Unlatch the cuckoo door. 6. Hang the pendulum on the clock, attach the weights, then wind the clock by pulling each weight up to the base of the clock (This is obviously where the setup process will differ if you purchased. Operating Instructions for Quartz Cuckoo Clocks Please read this operating instructions carefully before handling your clock. - Turn the hands clockwise till they point to 12 o’clock. - Open the back cover and insert 2 (for clocks with music 3) batteries type „Baby“ as indicated in the battery holder. Pay attention to + and -. OPERATING instructions. Silent Lever. Most River City Cuckoo clocks have a "silent" lever on the side or bottom of the case. Place the lever in the "on" position if you want your clock to "cuckoo" and play music (on models so equipped).